Managing File Transfer Resources › Issue Commands to a File Transfer Resource

Issue Commands to a File Transfer Resource

You can use the CMD command to issue commands to the following file transfer resources from your file transfer status monitor:

• Managers
• TCP/IP provider

Example: Display Statistics of a CONNECT:Direct Region

To display the statistics of a CONNECT:Direct region

1. Enter CMD beside the desired CDMGR resource at the file transfer status monitor.

   The CONNECT:Direct Commands panel appears.

2. Enter CMD INQUIRE STATISTICS at the command prompt.

   The current status of the selected CONNECT:Direct statistics logging facility appears.

   Note: The Commands panel is profiled to display write-to-operator (WTO) messages generated by the file transfer resource. For example, if you issue CMD against a CONNECT:Direct manager resource, the panel updates with any WTO messages generated by the CONNECT:Direct region for which the manager resource is defined.

Issue Commands to a Remote CONNECT:Direct Region

If you enter CMD beside a remote CONNECT:Direct CDMGR resource, the Command Entry panel appears.

To issue CONNECT:Direct commands to CONNECT:Direct running on a remote system

1. Enter the CONNECT:Direct command at the command prompt on the Command Entry panel.

   The command is issued.

Note: For available commands, see the user’s guide for the CONNECT:Direct product to which you want to issue commands.