Setting Up File Transfer Resources › Customize Managed CA XCOM Regions

Customize Managed CA XCOM Regions

You can use this procedure to customize a CA XCOM Data Transport region to work with this product.

To customize a managed CA XCOM Data Transport region

1. Ensure that the values of the following parameters in the CA XCOM Data Transport Default Options Table are set as follows:
   • NETMAST=YES
   • RECVRID=xcom-event-receiver-id

     The value of the RECVRID parameter must match the CA XCOM Data Transport event receiver ID specified in the XCAPI parameter group of CA NetMaster FTM. If the parameter is not specified, it assumes the value $RFFTEVR.

   • ERRINTV=error-retry-interval

     Use a low value for the ERRINTV parameter to ensure that accurate transfer request status is displayed on the monitors. You can either use the default parameter or use a lower value.

2. Reassemble and link the Default Options Table.

   Note: This step only applies if you make changes to the default parameters.

   The remaining steps are required only if one of the following applies:

   • You have not already applied the CA XCOM Data Transport user modification (USERMOD) for CA NetMaster support (as part of previous installation of CA NetMaster FTM).
   • You are upgrading CA XCOM Data Transport to r11.
3. (This step is for r11.0 and below only.) Copy one of the following job members, depending on your version of CA XCOM Data Transport:
   • If you are managing an Advantage CA XCOM Data Transport 3.1 region (or a previous release), copy the dsnpref.NMC1.CC17SAMP(XCUSRMOD) job member to the dsnpref.NMC1.rname.JCL data set.

     The job applies user modification (USERMOD) to include the exit in the CA XCOM Data Transport region.

   • If you are managing a CA XCOM Data Transport r11 region, copy the dsnpref.NMC1.CC17SAMP(XCUSRM11) job member to the dsnpref.NMC1.rname.JCL data set.

     The job applies user modification (USERMOD) to include the exit in the CA XCOM Data Transport r11 region.

4. (This step is for r11.0 and below only.) Review the comments in the copy, and update the variables that start with a question mark (?).
5. (This step is for r11.0 and below only.) Submit the customized job.
6. Restart the CA XCOM Data Transport region.