The Network Setup page identifies the network configuration that was created when you installed the Multi-Port Monitor software and you enabled network access. For more information, see the CA ADA Multi-Port Monitor Installation Guide that was shipped with your appliance.
You can use the fields on this page to change the network configuration.
The selection in this field determines the contents of the other fields on this page. Select an interface and click Set before changing the information in the remaining fields. The page refreshes and indicates whether the interface has IPv4 addresses.
Select this option to use DHCP (Dynamic Host Configuration Protocol) to obtain the IP address of the management NIC. You can provide the DHCP host name of the management NIC.
Select this option to type the IP Address, Subnet Mask, and Default Gateway Address of the management NIC.
Note: The IP address of the management NIC must match the IP address that is assigned to Multi-Port Monitor in the CA Application Delivery Analysis management console.
Type the IP address of the local DNS server in the "DNS server 1" field.
(Optional) Type the IP addresses of secondary DNS servers in the "DNS server 2" and "DNS server 3" fields.
Click to preserve your changes to network settings.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|