EMS Integration Profiles are used to discover devices and their components in your network. You can manually start an EMS Integration profile to begin discovery.
Note: Alternatively, you can wait until the inventory poll schedule is reached for discovery to begin automatically.
Follow these steps:
The EMS Integration Profiles page opens, displaying a list of available discovery profiles.
Note: You can only run a discovery on an EMS integration profile that has a status of 'READY'.
A confirmation dialog opens.
The Discovery starts. The Status column for the selected Discovery profiles indicates 'Started'.
A confirmation dialog opens.
Devices and all of their associated interfaces are discovered and polling begins. You are returned to the EMS Integration Profiles page.
If discovery hangs for more than 10 minutes, Data Aggregator stops it. Data Aggregator considers a discovery to be hanging when no new devices are discovered within 10 minutes and the state for the selected discovery profiles have not changed within 10 minutes. An audit event is generated on the discovery instance item. If no devices were discovered successfully, the Status column for the selected discovery profiles indicates 'FAILURE'. If at least one device but not all devices were discovered successfully, the Status column indicates 'PARTIAL_FAILURE'.
The discovered devices and components can take up to 5 minutes to synchronize with CA Performance Center. When the synchronization is complete, the discovered devices and components appear in the Inventory tab in CA Performance Center.
|
Copyright © 2013 CA.
All rights reserved.
|
|