Starting Up › Start the SOLVE SSI Region

Start the SOLVE SSI Region

You only need to perform this procedure if you use a new SOLVE SSI region.

Notes:

• If you are using an existing shared SOLVE SSI region and did not make any changes when specifying the SOLVE SSI region, skip this procedure.
• If you are using an existing shared SOLVE SSI region and have made changes, skip this procedure and proceed to restarting the SOLVE SSI region.

The SOLVE SSI region only needs to be started for the following reasons:

• Your NetMaster product regions will be linked in a multisystem network using EPS (End Point Services).
• The Alert Monitor will receive external alerts from CA OPS/MVS Event Management Automation.
• The NetMaster PPI (rather than the NetView PPI) is to forward generic alerts from a NetView region to your NetMaster product region.
• In-house development makes use of the NetMaster PPI.
• In-house development makes use of the DD SUBSYS facility.

To start the SOLVE SSI region, issue the following command from the MVS console:

S ssiname

ssiname is the name you specified for the SOLVE SSI during the setup process.

To stop the SOLVE SSI started task, issue the following command from the MVS console:

F ssiname,FSTOP

Note: If you are using cross-memory services and the SOLVE SSI is terminated, the address space ID is not available until after the next IPL.