Configuring Your Product › Specify the SOLVE SSI Region

Specify the SOLVE SSI Region

Use this procedure to provide communication between the product region and other software on a system.

To specify a SOLVE SSI region

1. At the ISPF/PDF TSO Command Shell prompt, execute the following command:

   EXEC 'dsnpref.NMC0.CAIJCL(INSTALL)'
   

   The Install Utility panel appears.

   Note: On each of the Install Utility panels, you can use the following keys:

   • Enter to proceed to the next panel
   • F1 to display the online help
   • F3 to return to the previous panel
   • F4 to exit and return to the main menu
2. Press Enter.

   The Install Utility Primary Menu panel appears.

3. (Optional) If you have installed the product using CA MSM, perform the following steps:
   1. Enter 1.

      The Software Delivery Method panel appears.

   2. Complete the panel:
      • Enter S next to CA MSM.
      • Specify the name of the CSI data set used during product installation in the SMP/E CSI Used field.
   3. Press Enter.
4. Enter 4.

   A panel appears listing several approaches to implement your SOLVE SSI environment.

   Note: For more information, press F1 (Help).

5. Press Enter.

   The SETUP SOLVE SSI Primary Menu panel appears.

6. Enter 1 (Add a Region).

   The SETUP Specify SOLVE SSI Name panel appears.

7. Enter the name (ssiname) and description of the SOLVE Subsystem Interface region you are setting up. The initial value is SOLVESSI.

   The setup software uses the name to generate the started task JCL. For example, if the name is SOLVESSI, your started task JCL is named SOLVESSI.

8. Complete each of the SETUP panels as they appear. You can accept the default values or specify site-specific values. For information about the fields, press F1 (Help).

   The Install Utility generates a series of setup jobs into the dsnpref.NMC0.ssiname.JCL library.

9. Record the name of the data set into which the JCL was generated in your post-installation worksheet.

   Note: If you want to set up a new SSI, continue with these steps. Otherwise, skip the remaining steps in this procedure, verify that the required SSI parameters are present in your existing shared SSI, and update them as necessary.

10. Submit and run the following:
    • S01LCALC

      Allocates the SOLVE SSI data sets if the value in the Enable the Packet Analyzer field on the SETUP Region Parameters panel is set to YES.

    • S02LDPDS

      Copies the PDS members to dsnpref.NMC0.SSIPARM.

    • S03MIGRT

      Copies data from earlier releases.

      This job is only generated if the value in the Enable the Packet Analyzer field on the SETUP Region Parameters panel is set to YES.

11. Press F3.

    The Install Utility Primary Menu panel appears.