To display information about linkages that have been defined for a command source, specify the LINK parameter on the DISPLAY command. The default value is SOURCE. Identify the command source for which you want information by specifying one of these parameters on your command:
Displays all linkages allowing local sources to issue cross-system commands.
Displays linkage information for the source that issued the DISPLAY LINK command.
Displays linkages that enable one or more users on the local system to issue cross-system commands. Specify USER=ALL to display linkages for all local users, or specify a user ID on the USER operand to display linkages for one user ID.
The following illustration shows you how to issue the DISPLAY LINK ALL command from a console:
MI DISPLAY LINK ALL MIM3016I GCMF Cross-System Linkage DISPLAY --- SOURCE --- TARGET CONS -AUTH- ------- TARGET SYSTEMS -------- USER(OPERATER) Pool SRCE ALL USER(MIMGRDEV) Pool ALL ALL USER( ALL ) Pool SRCE ALL
|
Copyright © 2014 CA.
All rights reserved.
|
|