Possible Cause:
TPCF is not set up to automatically respond to this message.
Solution:
Initiate the TPCF AUTOREPLY feature with the command SETOPTION AUTOREPLY=ON.
Possible Cause:
The reply limits for ALLOC_OFFLN and SPEC_WAIT parameters in SYS1.PARMLIB(ALLOC00) member are set too low.
Solution:
Modify the MAXNWAIT parameters for ALLOC00, or use the TPCF AUTOREPLY options to override the z/OS values.
Possible Cause:
The job may also produce a diagnostic dump with the title 'FAILURE IN MIA ALLOCATION RECOVERY PROCESSING, CALLER NOT IDENTIFIED.'
Solution:
Contact CA Technical Support if you receive this dump.
|
Copyright © 2014 CA.
All rights reserved.
|
|