System HOLDDATA indicates data that is an in-stream part of the SYSMOD, informing you of special conditions. The following reasons are used with SYSTEM HOLDDATA for your product:
Indicates that you must perform special processing before or after you apply this SYSMOD.
Affects automated operations. It changes either the message identifier or the displacement of a field inside the message.
Indicates that data sets and DDDEFs are being added or modified.
Deletes the SYSMOD load module. You cannot reverse this type of SYSMOD with the SMP/E RESTORE command.
Indicates a dependency for this SYSMOD that you must externally verify.
Indicates a documentation change with this SYSMOD.
Indicates that the SYSMOD must be installed in both the Active and Alternate Extended Recovery Facility Systems.
Indicates that an IPL is required for this SYSMOD to take effect. This is used only when there is no alternative for dynamic activation.
Code a bypass operand on your APPLY command to install SYSMODs that have internal holds. Code the bypass operand only after you have performed the required action, or if you are performing the action after the APPLY, if that is appropriate.
|
Copyright © 2014 CA.
All rights reserved.
|
|