7. PARAMETERS › 7.2 VTS Component Parameters › 7.2.3 VTS Component Unit Level Parameters › 7.2.3.2 Input Specification (INPUTVTS) and(INPUTRDR) › 7.2.3.2.2 INPUTVTS PARMS Member JCL Definition

7.2.3.2.2 INPUTVTS PARMS Member JCL Definition

The INPUTVTS member of prefix.MICS.PARMS contains the DD
statements to specify the input data for the VTS component.
It contains the input SMF data sets when ANY of the following
JCLDEF options is used:
 
o DAYSMF OFF is specified
 
o SMFDRCTR/SMFDIRECTOR VTS is specified
 
o DAYSMF EXCLUDE VTS is specified
 
A //INPUTSMF DD statement is required for each SMF data
source.
 
A //SMFDRCTR DD statement is only required when CA SMF
Director split indices are used.
 
Note:  If your site has CA SMF Director installed, you can
use it to extract specific SMF record types and subtypes at
SMF dump time. For more details on this feature, see Section
6.2.3, CA MICS and CA SMF Director Interface.
 
If you change the contents of the INPUTVTS member, you must
regenerate the DAILY job using either JCLGENU or JCLGEND in
prefix.MICS.CNTL.
 
The INPUTVTS member can contain JCL definitions for non-SMF
input such as data from the new generation of IBM VTS
systems, the Tape Server TS77xx series, or data from
independent sequential data sets. Instead it can contain JCL
definitions for SMF input if you do not specify SMFRECORDING
VTS in prefix.MICS.PARMS(JCLDEF).  If SMFRECORDING VTS is
specified in JCLDEF, it must be defined in the input JCL in
the INPUTRDR member in prefix.MICS.PARMS.
 
o  If you specified HYDRA on the OPTION statement in
   sharedprefix.MICS.GENLIB(VTSGENIN), supply the data sets
   extracted from the TS77xx using the Bulk Volume
   Information Retrieval (BVIR) facility in INPUTVTS using
   the INPUTBVR ddname.
 
//@  IBM BVIR Input
//INPUTBVR  DD DISP=SHR,DSN=hlq.BVIR.data(0)