7. PARAMETERS › 7.2 VTS Component Parameters › 7.2.3 VTS Component Unit Level Parameters › 7.2.3.1 VTS Processing Options (VTSOPS)

7.2.3.1 VTS Processing Options (VTSOPS)

This section shows you how to specify the operational
statements that control unit level processing of the VTS
component.

Operational statements are stored in the prefix.MICS.PARMS
cccOPS member, where ccc is the component identifier, and are
incorporated into the CA MICS system by running the
prefix.MICS.CNTL(cccPGEN) job.

*************************************************************
*                                                           *
*  NOTE:  CHANGES to prefix.MICS.PARMS(cccOPS) members      *
*         REQUIRE EXECUTION of prefix.MICS.CNTL(cccPGEN)    *
*         to take effect.                                   *
*                                                           *
*         In addition, any change to parameters that        *
*         impact the DAILY operational job JCL such as,     *
*                                                           *
*         o  changing RESTART NO to RESTART YES,            *
*                                                           *
*         o  WORK parameter changes when RESTART NO is in   *
*            effect,                                        *
*                                                           *
*         o  Specifying TAPEfff (if this product supports   *
*            a DETAIL level TAPE option),                   *
*                                                           *
*         o  or changes to prefix.MICS.PARMS(INPUTccc),     *
*                                                           *
*         will require regeneration of the DAILY job by     *
*         executing prefix.MICS.CNTL(JCLGEND) or by         *
*         specifying DAILY in prefix.MICS.PARMS(JCLGENU)    *
*         and executing prefix.MICS.CNTL(JCLGENU).          *
*                                                           *
*         Refer to the checklist (if provided) for updating *
*         cccOPS parameters and running required generation *
*         jobs.                                             *
*************************************************************
 
Review the defaults provided in VTSOPS.  In general, the
defaults have been chosen to provide out-of-the-box operation
for most customer environments.  If the defaults meet your
site's requirements, you do not need to tailor VTSOPS.


General Syntax Rules

o  Comments are accepted and signified by an asterisk (*) as
   the first non-blank character.

o  Statement names and values can be entered in either
   uppercase or lowercase characters.

o  Statements can start anywhere in columns 1-72.  Only one
   statement per line is supported.

o  Statements can appear in any order.

The following sections explain each of the option statements
that can be specified in prefix.MICS.PARMS(VTSOPS).

Note:  The SMFTYPE, WORK, RESTART, and Incremental Update
       statements are applicable for all VTS component units
       regardless of data source.

       The UNKNOWNVTSID and VTSSYSID statements are
       applicable only for units processing IBM VTS data.

       The RTDMOUNTTIME and VTVMOUNTTIME statements are
       applicable only for units processing StorageTek VSM
       data.

Required Statements
-------------------

o None

Optional Statements
-------------------

o SMFTYPE Statement
o UNKNOWNVTSID Statement
o VTSSYSID Statement
o RTDMOUNTTIME and VTVMOUNTTIME Statements
o WORK, MULTWORK, and NOMULT Statements
o RESTART Statements
o Incremental Update Statements