Appendix A: MESSAGES › 9.2 DAILY Update Processing Flow › SNT00218

SNT00218

+-----------------+
| S N T 0 0 2 1 8 |
+-----------------+

TEXT:        REPORT %REPORT; THE LABEL FOR %ACTVAR HAS BEEN
             CHANGED.

TYPE:        Error

REASON:      The CA MICS Network Analyzer produces two
             reports based on the data element SNTACT3.
             Normally, the value of SNTACT3 equals the value
             in the data element Secondary Logical Unit
             Physical Unit (SLUPU).  You may change this
             value using the SNTACCT parameter and SNTACRT
             exit.  If you do this, the two reports are no
             longer valid and the report generator (GNSNTRPT)
             checks the SAS label on SNTACT3.  This message
             is issued if the value of SNTACT3 is not the
             same as the default value (SLUPU) shipped by CA.

ACTION:      If your site requires the SNT113 and SNT213
             reports, you must restore the value of SNTACT3
             to the default value (SLUPU).

REFERENCES:  See Chapter 3 of this guide for information
             regarding the reports, and Chapter 7 for a
             discussion of the SNTACCT and SNTACRT
             parameters.