1. OVERVIEW › 1.5 Online Facility Tutorial › 1.5.4 Capacity Planning Analysis Inquiries › 1.5.4.5 Executing an Analysis Inquiry › 1.5.4.5.4 Selecting Execution-Time Data
1.5.4.5.4 Selecting Execution-Time Data
The online facility analysis inquiries are made more general
in that they allow you to specify information such as the
range of CA MICS file cycles or the system identifier (SYSID)
to be reported on at execution time. When you select an
analysis inquiry for execution, the online facility presents
you with the Execution-Time Parameters screen. Figure 1-21
shows an example of this screen after the Database ID and
CA MICS File Cycles have been entered. The content of the
Execution-Time Parameters screen changes depending on the
type of analysis you are executing, but the format is the
same as that in Figure 1-21. To execute the analysis
inquiry, type END after the Command prompt and press ENTER,
or press (usually) your PF3 key.
/------------------------- Execution-Time Parameters -------------------------\
|Command ===> Scroll ===> CSR |
|Press END to execute the inquiry. Enter CANCEL to cancel inquiry execution. |
|Executing CA MICS Inquiry: CLUC1 - Workload Characterization |
| |
|-------------------------------------------------------------------------------|
| Enter the Data Base ID. (1 character) for the Data Base to be processed. |
|A - ___________________________________ |
| |
| Enter the range of CA MICS File Cycles (e.g., 01 - 04) to be processed. |
|01 - 02 |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
\------------------------------------------------------------------------------/
Figure 1-21. Execution-Time Parameters Screen
Copyright © 2014 CA.
All rights reserved.
|
|