2. Planning for Installation and Use of CA MICS › 2.3 Installation Planning and Parameter Specification › 2.3.3 CA MICS JCL Planning and Parameters › 2.3.3.2 Standard JCLGEN Parameters › 2.3.3.2.1 JCL Option Definitions (JCLDEF) › 2.3.3.2.1.2 Database Unit Library Definitions

Previous Topic: 2.3.3.2.1.1 Database Unit Control Definitions

Next Topic: 2.3.3.2.1.3 Database Unit Execution Option Definitions
2.3.3.2.1.2 Database Unit Library Definitions

The following parameter statements are identical in purpose
to those found in sharedprefix.MICS.PARMS(JCLDEFC), described
in section 2.3.1.6.2.

    ISPLLIB1-2    ISPMLIB1-2  ISPTLIB1-2  OBJACCESS
    OBJWAIT       PROCLIB     SASAUTOS    SASCONFIG
    SASCONFIG1-4  SASENV      SASHELP     SASLIB
    SASMSG        SASNAME     SASVER      SORTLIB
    STEPLIB1-2    USEROBJLIB

TSMLINK:

    For CA TSO/MON PM users running Release 5, the TSMLINK
    statement specifies a fully qualified name of the CA
    TSO/MON PM load library. CA MICS loads the CA TSO/MON PM
    parameter parsing module from this library. If the CA
    MICS Analyzer for TSO is not installed in this unit or if
    the CA TSO/MON PM load modules are contained in the
    system LPA or LINKLIST libraries, comment out this
    statement.

    For CA TSO/MON PM users running Release 6, do not code
    the TSMLINK statement.


TSMPARMS:

    For CA TSO/MON PM users running Release 5, the TSMPARMS
    statement specifies a fully-qualified name of the CA
    TSO/MON PM parameter library containing your current
    commands table. CA MICS calls a CA TSO/MON PM program
    that reads your command table which is used to translate
    CA TSO/MON PM's two-character command abbreviations back
    into the full-length real names of the TSO commands. If
    the CA MICS Analyzer for TSO is not installed in this
    unit, comment out this statement.

    For CA TSO/MON PM users running Release 6, do not code
    the TSMPARMS statement.