Specifying the TO Data Set

Enter the TO library or data set information in the appropriate fields of the TO data set panel.

If the TO data set is partitioned or CA Librarian:
- and the FROM data set is sequential, enter the TO member name.
- and a FROM member name was entered, enter the TO member name only if you want to give the member a different name (renamed) in the TO data set.
- and the FROM member field was set to asterisk, do not specify a TO member name. You are not allowed to rename members in this case.
- and the FROM member field was left blank, do not specify a TO member name.
You can specify new names on the member selection list.
If the TO data set is CA Librarian, and the TO member exists, and the TO library is NOBYPP, then specify the password for the TO member.

Before proceeding, enter or verify the following options on the second move/copy utility panel.

If the TO data set is partitioned or CA Librarian, then replace like‑named members.
- Enter YES to allow the replacement or update of members in the data set, depending on whether the Wide Record Conversion Utility Copy is being used. See the section on the Wide Record Conversion Utility Copy for more details.
- Enter NO to prevent replacement of members in the data set.
If the TO data set is sequential, in “To” data set disposition:
- Enter OLD to overwrite existing data in the data set.
- Enter MOD to add to the end of the data set.
If the FROM data set is partitioned or sequential, in CA Librarian “number mode:”
- Enter OFF to use external numbers (81,6,10,10).
- Enter COB to use COBOL numbers (1,6,10,10).
- Enter STD to use standard numbers (73,8,10,10).
- Enter DEF to use the CA Librarian master file SEQ default.
If you choose COB or STD, use the existing numbers for ADDing a new member:
- Enter YES to use the existing sequence numbers.
- Enter NO to generate new sequence numbers.
Note: If you enter YES, be sure that the member has valid numbers in the field referenced by the number mode. Otherwise, an error condition results.