The ELIPS RECOVER command queries the edit recovery table for pending entries.
During ELIPS EDIT, when the edit profile specifies RECOVERY ON, the changes made to the edit data between SAVES are automatically journaled by the editor in a recovery backup data set.
Should the edit session end abnormally, then the edit session can be recovered upon re-entering ELIPS.
When you enter ELIPS, the recovery table is automatically queried for pending entries. If there is more than one pending entry (or the user deferred the recovery), then the RECOVER command recovers the next entry, without having to exit ELIPS.
COMMAND ===> ***************************************** *ELIPS EDIT FUNCTION: AUTOMATIC RECOVERY* ***************************************** The following LIBRARIAN member was being edited by the ELIPS edit function when the session was abnormally terminated: LIBRARY: LIBR.BRANTON.TESTMAST MEMBER: COBMOD VERSION: 900424141752 STATUS: TEST PASSWORD ===> MCD ===> Instructions: Press ENTER key to continue editing the module, or Enter END command to return to the ELIPS entry panel or selection list, Enter DEFER command to defer recovery of the member, or Enter CANCEL command to cancel recovery of member. Enter TOP command to defer recovery of this member and redisplay recoveries pending starting at the first one
The LIBRARY, MEMBER, VERSION and STATUS are non-modifiable fields that identify the member at the current position in the recovery table. This is the edit session that is recovered when you press ENTER. The PASSWORD field is for entering that information, if required.
You can decide to recover the edit session, defer the recovery to a later time, or cancel it altogether.
|
Copyright © 2003 CA.
All rights reserved.
|
|