The ELIPS edit MOVE command moves a partitioned data set member or sequential data set into the edit data. Move means that the data is copied and then the PDS member or sequential data set is deleted.
Use the A (After) or B (Before) line commands to specify where to place the data in the edit data or use AFTER/BEFORE .label on the command line.
To preserve the audit trail, MOVE is not supported from CA Librarian libraries.
This command has the following format:
MOVE [»AFTER Œ .label]
[»BEFOREŒ ]
All parameters are optional.
The position of the new data relative to the insertion point, after or before that point.
The line as the insertion point to move the data.
The extended move panel displays allowing for the specification of the data set name. If the data set is partitioned, a blank or WILDCARD member name displays a member selection list. You can also specify the format for the list on the panel as L for long or S for short.
|
Copyright © 2003 CA.
All rights reserved.
|
|