Installing Your Product from Tape › Apply Maintenance

Apply Maintenance

CA Support Online may have maintenance and HOLDDATA that have been published since the installation data was created.

To apply maintenance

1. Check CA Support Online and download any PTFs and HOLDDATA published since this release was created.
2. Transfer the downloaded files to two separate FB 80 sequential data sets. Use one data set to contain the PTFs and the other to contain the HOLDDATA.

   The PTFs and HOLDDATA become accessible to the yourhlq.SAMPJCL maintenance members.

3. The LIBSEDIT macro was customized in the installation steps. Verify that you still have the values from the base install.
4. Open the SAMPJCL member LIB6RECP in an edit session and execute the LIBSEDIT macro from the command line.

   LIB6RECP is customized with your jobcard, CSI location, and zone names.

5. Customize the LIB6RECP SMPPTFIN and SMPHOLD DD statements to reference the FB 80 data sets for the PTFs and HOLDDATA.
6. Submit LIB6RECP.

   The PTFs and HOLDDATA are received.

7. Open the SAMPJCL member LIB7APYP in an edit session and execute the LIBSEDIT macro from the command line.

   LIB7APYP is customized.

8. Submit LIB7APYP.

   The PTFs are applied.

9. (Optional) Open the SAMPJCL member LIB8ACCP in an edit session and execute the LIBSEDIT macro from the command line.

   LIB8ACCP is customized.

10. (Optional) Submit yourhlq.SAMPJCL member LIB8ACCP.

    The PTFs are accepted.

    Note: You do not have to submit the job at this time. You can accept the PTFs according to your site's policy.