CA JCLCheck Runtime Options › Description of Runtime Options › AUTOPROC

AUTOPROC

The AUTOPROC option extracts the cataloged procedure library (PROCLIB) from the JES2 or JES3 address space. With this option activated, it is not necessary to maintain PROCLIB allocation information in the CA JCLCheck cataloged procedures, CLIST, or SUBCHEK/EDCHEK control files.

This option has the following format:

AUtoproc|NOAUtopr

Default: NOAUtopr

When AUTOPROC is specified in a batch execution of CA JCLCheck, the SYSPROC and other PROCLIB allocation DD statements normally required in the execution JCL must be omitted.

When AUTOPROC is specified in a SUBCHEK or EDCHEK control file, the ddnames used in the JES2 procedure (for example, PROC00, PROC01) or JES3 procedure (for example, IATPLBST) must not already be allocated to the TSO session.

• If the allocation of the procedure libraries is successful, these libraries are searched for the procedures. The ddnames that are supplied by the PROC option are ignored.

  If the allocation of the procedure libraries is unsuccessful, the CAY6182S message is issued and the ddname that is supplied by the PROC runtime option (if allocated) is the target of the procedure library search.

  Specifically, AUTOPROC is in effect unless there is an error message indicating the allocation failed.

• The AUTOPROC option requires that CA JCLCheck is APF authorized.
• The AUTOPROC option is not available when executing CA JCLCheck under VM/CMS or CA Roscoe Version 5.6 and below.
• The AUTOPROC option is not available on Fujitsu MSP operating systems.
• The AUTOPROC and NORUNTim options are mutually exclusive with the following four exceptions:
  • CA JCLCheck Common Component with CA WA CA 7 Edition
  • CA JCLCheck Common Component with CA Scheduler
  • CA JCLCheck Common Component with CA WA ESP Edition
  • CA JCLCheck Full Product
• The AUTOPROC option on JES3 is supported only on the master system that owns the PROCLIBS.
• The AUTOPROC option on JES3 supports only static defined proclibs.
• The AUTOPROC option on JES2 supports static proclibs, JOBCLASS definitions, and DYNAMICALLY added PROCLIBS that are supported by z/OS 1.2 and above.
• The AUTOPROC option uses the DDNAMES as specified in JES2, such as, PROC00, PROC01... Care must be taken so as not to duplicate allocations to the same DDNAME when using the EDCHKDD ALLOC commands. If a duplicate allocation is detected, message CAY6300 is issued with a DAIR code of 0410. When allocating procedure libraries, use either AUTOPROC option or the EDCHKDD ALLOC commands, not both.

Also, review the related option DFLTJOBC (Default Job Class).