The XCF command interacts with the physical XCF communications manager. The purpose of this component is to maintain Sysplex-wide awareness of active LPARs and GTS-to-GTS connection on the basis of XCF.
This command has the following format:
F gts,XCF keyword
Modifies the generation of debugging messages. This should only be turned on at the request of CA Support.
Displays information about all systems in the Sysplex, including if other GTS' are active on these systems. If another GTS is active on a system, additional information is shown.
An existing connection should imply connectivity to this system, but the only authoritative answer is available via the COMM INFO command.
Example:
F GTS,XCF INFO CAGS03960I General system information for GTS CA11 follows CAGS03980I Current system is identified as: CAGS03990I XCF: CA11, hardware: MF01, LPAR: CA11, GRS: CA11, SMF: CA11 active on Sysplex PLEXC1, clone ID: 11 CAGS04000I Operating system release: SP7.1.7, FMID: JBB772S, IPL'd on 16:05:19 - 2006 CAGS04010I This GTS is active in XCF group ROLF1, as member M489, token 020005B0 00500001 CAGS04030I Sysplex-wide information: CAGS04040I System: CA31 , clone ID: 31, status: ACTIVE, GTS connected: NO , managed by: N/A CAGS04040I System: XE61 , clone ID: 61, status: ACTIVE, GTS connected: NO , managed by: N/A CAGS04040I System: CA11 , clone ID: 11, status: ACTIVE, GTS connected: YES, managed by: CA11 CAGS04050I Member name: M489 , token: 020005B0 00500001, JOB/STC/TSU: CA7GS CAGS04040I System: XAD1 , clone ID: D1, status: ACTIVE, GTS connected: NO , managed by: N/A
|
Copyright © 2013 CA.
All rights reserved.
|
|