Source Listing Facility › Run Your Program

Run Your Program

After setting monitoring and breakpoints for each program you want to test, you are ready to begin testing. To begin testing, perform the following steps:

1. Exit the Source Listing facility by pressing PF3 or Clear. If you accessed a CA InterTest for CICS screen outside the Source Listing facility, you might have to press Clear more than once to return to CICS. CA InterTest for CICS responds with the message:

       Lister Function Terminated.
   

2. Initiate the program as you normally would from CICS. Depending on the breakpoints you set and the processing paths your program takes, one of the following occurs:
   • CA InterTest for CICS stops the transaction at a breakpoint (either one you set or one CA InterTest for CICS automatically triggered) because the program was about to violate a CICS coding standard.
   • The application runs to completion without being stopped by CA InterTest for CICS. The results might not be correct.

Note: If the program ends and you get incorrect results or need to test other logic paths, initiate LIST again and set additional breakpoints before retesting the program. You do not have to reset monitoring—it remains in effect until specifically removed.