Source Listing Facility › Customize the Source Listing Profile › Breakpoint Display Mode

Breakpoint Display Mode

CA InterTest for CICS has two breakpoint displays:

• The Source Listing Breakpoint version lets you to test directly from your source listing.
• The Detailed Breakpoint display requires you to use one‑line CA InterTest for CICS commands and other menus.

The initial display mode depends on the setting chosen when CA InterTest for CICS was installed; however, you can change the display mode at any time by using the Profile screen. This change remains in effect until the Source List BKPT= setting is changed.

Source List BKPT=

To change the breakpoint display mode, perform the following steps:

1. Type profile on the command line and press Enter, or press PF4 to display the Profile screen. The Source List BKPT= field shows the current setting.
2. Overtype the current value with one of the following:

   ON

   Displays the Source Listing Breakpoint.

   OFF

   Displays the Detailed Breakpoint.

3. Press Enter to process the new setting and to return to the Source Listing Display screen.

   Note: The default value of the Source List BKPT= field is a system‑wide, CA InterTest for CICS installation option. To change the default value, have your System Administrator consult the Installation Guide.