Using CA InterTest for CICS with DB2 and SQL/DS Programs › Preliminary Steps › Check for DB2 or SQL/DS Support

Check for DB2 or SQL/DS Support

CA InterTest for CICS should have been installed with DB2 or SQL/DS support if you are going to monitor DB2 or SQL/DS application programs.

To ensure that DB2 or SQL/DS support was installed, follow these steps:

1. Access the Request Breakpoint Selection menu. This menu is displayed when you select the Request option from a Monitoring program, such as Monitoring Programs (2.1), Monitoring Transactions (2.2), or Monitoring Terminals (2.3). The chapter "Using Breakpoints" describes how to access this menu.
2. Inspect the first input line on the menu. If it contains either of the following, DB2 or SQL/DS support was installed. If the DB2 or SQL/DS field is missing, support is not installed.DB2 or SQL/DS support was installed. If the DB2 or SQL/DS field is missing, support is not installed.

                                                í    
   _ ALL commands   _ All macros   _ DL/I   _ DB2     _ CALLS
   
   

                                               í   
_ ALL commands   _ All macros   _ DL/I   _ SQL/DS  _ CALLS

If you monitor DB2 or SQL/DS programs without the appropriate CA InterTest for CICS support, your programs are halted at an automatic breakpoint each time the program issues a DB2 or SQL/DS call. If necessary, contact your system programmer and request DB2 or SQL/DS support.

Note: The Installation Guide explains how to install this support.