CNTL Commands and Menus › Initiate Monitoring › Set SystemWide Options › Example

Example

The following screen shows how to specify task resumption.

This screen specifies that the task:

• Resume at a new location: TASK‑NUMBER‑FOR‑MSG.
• Execute three COBOL verbs before halting again.

 CA InterTest MONITORING COMMAND BUILDER  RESUME TASK EXECUTION     33
                                                                               
 Press ENTER without options to resume execution of the breakpointed task  _____ 
        OR    enter one or more of the following options:                      
 
 To RESUME EXECUTION at a different location, enter ONE new location:          
      COBOL paragraph, Assembler or PL/1 label:  tasknumberformsg____________ 
      COBOL or PL/1 statement number: _____      Offset: _____                 
                                                                               
 To MOVE this breakpoint enter ONE new location,  OR  enter X to DISABLE it:   
      COBOL paragraph, Assembler or PL/1 label:  _______________________________
      COBOL or PL/1 statement number: _____      Offset: _____                 
 To AUTO STEP, enter #n for COBOL verbs or PL/1 STMTS or n for instrucs:   #3___
 with a n second WAIT between breakpoints:____
 to HALT at a CALL, enter XOR after n steps are reached:____ 
                                                                               
 To take a DUMP before continuing, enter a 1 to 4 digit dump code:          ____
 To ABEND transaction, enter dump code or XXXX if no dump is desired:       ____