Installation Guide › JBoss Version › Installation on a JBoss Cluster › How to Install CA IdentityMinder on a JBoss Cluster › Configure the JK Connector

Configure the JK Connector

Follow these steps:

1. Install a JK connector based on these instructions:

   http://community.jboss.org/wiki/usingmodjk12withjboss

2. Note the following when you use this procedure:
   1. When you configure the modjk workers, use the workers.properties file in this location:

      Windows: C:\Program Files\CA\Identity Manager\IAM Suite\Identity Manager\tools\samples\ConnectorConfiguration\windows\IIS_JBoss

      UNIX: /opt/CA/IdentityManager/IAM_Suite/Identity_Manager/tools/samples/Cluster/JBoss/ConnectorConfiguration

   2. In this file, replace worker.workerN.* (the worker name) with your corresponding node’s Peer ID.

      If you have more than two nodes, copy a worker.workerN.* set for each additional node and rename the worker name.

   3. Fill in the worker.workerN.host field with your corresponding nodes’ hostnames.

      For example, consider a cluster where the CA IdentityMinder server is installed on three JBoss hosts named myhostA, myhostB, and myhostC, using Peer IDs 1, 2, and 3. The workers.properties file appears as follows:

      worker.worker1.port=8009
      worker.worker1.host=myhostA
      .
      .
      .
      worker.worker1.recovery_options=28
      
      worker.worker2.port=8009
      worker.worker2.host=myhostB
      .
      .
      .
      worker.worker2.recovery_options=28
      
      worker.worker3.port=8009
      worker.worker3.host=myhostC
      .
      .
      .
      worker.worker3.recovery_options=28
      .
      .
      .
      worker.router.balance_workers=worker1,worker2,worker3
      

   4. Copy the uriworkermap.properties file in the above location to APACHE_HOME/conf.
   5. Omit the step about configuring Tomcat for session stickiness. This feature is already configured by the installer and in the workers.properties file.