Connector Guides › Connectors Guide › Managing CA IAM CS › Logging › Configure Logging for CA IAM CS

Configure Logging for CA IAM CS

The following configuration file affects the jcs_daily.log and servicemix.log files that are listed in View a Log:

cs-home/etc/org.ops4j.pax.logging.cfg

This file defines logging for CA IAM CS, including the following:

• The logging levels for each of the components in CA IAM CS.
• Whether log files are appended daily
• The formatting of the lines that are written to the log

You can use these methods to configure logging for CA IAM CS:

Method 1 (Recommended): Load preformatted versions of the CFG file

Use the following buttons on the Log File tab in CA IAM CS:

Load Production

Enable minimal logging for production environments. This configuration has a low impact on performance.

Load Verbose

Enables verbose logging, which is useful for analyzing faults.

Verbose logging can make CA IAM CS run slowly. Use this configuration only during debugging.

Method 2: Edit the CFG file in the Log File tab in CA IAM CS

When you have finished editing, use these buttons to discard or save your changes:

Reload

Discard any changes that you have made, and get the latest version of the logging configuration file from the server. Reloading is useful if you have edited the file in the Log File tab.

Save

Upload your changed file to the server. The new logging configuration takes effect immediately. You do not need to restart any components.

Method 3: Edit the CFG file in a text editor

After you save the file, the new logging configuration takes effect immediately. You do not need to restart any components.