Connector Guides › Connectors Guide › Connecting to Endpoints › HP NonStop SAFEGUARD Connector › Installing the HP NonStop SAFEGUARD Agent › Step 2. Configure Your System › Run the Agent Processes

Run the Agent Processes

To manage your HP NonStop SAFEGUARD endpoints, you must run the agent processes. Perform the following procedures to start the agent processes:

From the TACL prompt on your HP NonStop SAFEGUARD system

1. Log on as SUPER.SUPER.
2. Issue the following commands:

   instvol.CARELSCR.CONNECT
   

   instvol

   The disk volume where the HP NonStop SAFEGUARD agent is installed.

   CASTART ALL
   

3. To stop the agent processes, type the following command:

   CASHUTDOWN ALL