Transported programs and panels must be handled somewhat differently than other CA Ideal entities, as follows.
Before loading a program at the receiving site, a receiving system with the same short system ID as the sending system must exist or must be created. For example, a program transported from system ABC must be placed into a system with the same short ID: ABC. You cannot change this name. However, do not create programs or panels being transported on the receiving system.
The only valid CA Ideal commands for transported programs are RUN, DEQUEUE, ALTER PROGRAM, and ASSIGN DATAVIEW. Any attempt to EDIT, DISPLAY, DUPLICATE, MARK STATUS, DELETE, or PRINT transported programs or panels results in errors (program not found). Remember that to run a transported program, you must be authorized on the receiving system for RUN‑PROD.
When running a transported program, you must specify the PROD version. You can either issue a command each time you run a transported program or you can issue other command as follows:
RUN pgm‑name VER PROD
SET SITE VERSION PROD
This establishes PRODUCTION as the default version for the site. You need to specify only the program name with RUN. If you have a SET VERSION command in your Signon Member, you must remove it so that it does not override the SET SITE command. Specify the PROD version to bypass the normal Datadictionary check because transported programs are not on the Datadictionary of the receiving site.
To delete transported programs and panels from the receiving system, use the batch utility VLSUTIL. For more information, see the CA IPC Implementation Guide.
Only a program that was transported can transport panels.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|