IDCMDDER04 - PROD DVW must have at least one "PROD" ELEMENT

Compile (CM) Messages › › IDCMDDER04 - PROD DVW must have at least one "PROD" ELEMENT

Reason:

No ELEMENTs in PROD status were found related to a dataview in PROD status.

Action:

A DATAVIEW in PROD status is related only to HIST status elements. Datadictionary 2.4 does not display such elements except through the DDUTILTY report, using the ALLV version number in the -RPT START transaction.
A DATAVIEW in PROD status is related to a mixture of non-PROD elements. Again, use the DDUTILTY report facilities to determine HIST status elements.
A DATAVIEW was copied to PROD status before its associated database elements were copied to PROD.

In the first two cases, you probably RESTORE the affected DATABASE to an appropriate TEST status that does not conflict with existing TEST versions of the DATABASE or any related $INTERNAL entity (that is, down through DATAVIEW). RESTORE the TEST DATAVIEWs to the same test version as the DATABASE you restored. It is necessary to MODIFY any dataview whose original PROD version was related to non-PROD elements, rerelating these elements through CA DD2.4 on the MODIFY prompter, using information from your research (above).

In the latter case, you need to COPY the associated TABLE to PROD, CATALOG the PROD version of the DATABASE, perform any AREA preparation by means of DBUTLTY as needed, and ENABLE the PROD DATABASE through CA DDOL before the PROD dataview can be cataloged.