Installation of CA ITCM › Installation of CA ITCM Using the Command Line in Windows › Installation Tool msiexec › Package-specific MSI Properties › MSI Properties for the ENC Gateway Server Package

MSI Properties for the ENC Gateway Server Package

The MSI install package for the ENC Gateway Server supports the following package-specific properties:

AGENT_SERVER

Scalability server the agent should connect to.

Value: System name or IP address

ENC_CLIENT_ENABLED

Specifies whether the ENC Client should be enabled when the ENC Gateway server is installed.

Value: 0 (leave inactive), 1 (make active)

ENC_SERVER_TYPE

Specifies the roles for the ENC Gateway server. This should be one or more of the following values listed in the table following, separated by spaces. An ENC Gateway server can operate in one or more roles. If a manager is specified, a server is automatically configured as well. The ENC Client is also automatically configured to register with this server.

If an ENC Gateway server only is configured, the client registers with this one too.

In the above two cases, the configuration parameters for the client are not required, except for ENC_CLIENT_ENABLED.

If only a router is configured, then both the client and router must register with another ENC Gateway server. This is done by setting the ENC_SVR_ADDR parameter.

ENC_SVR_ADDR

If installing an ENC Gateway router, this should be the ENC Gateway server that it will register with.

If installing an ENC Gateway registration server, this should be the ENC Gateway registration manager that it will register with.

Value: FQN of the ENC Gateway server or manager to register with.

Note: If installing an ENC Gateway manager, then this is configured automatically.

ENC_SVR_TCP_PORT

TCP port on the ENC Gateway manager to connect to.

Default: 443

Note: If installing an ENC Gateway manager, then this is configured automatically.

ENC_SVR_HTTP_PORT

HTTP port on the ENC Gateway manager that the ENC Gateway registration server or router will connect to.

Default: 80

Note: If installing an ENC Gateway registration manager, then this is configured automatically. This needs only be set for Gateway servers or routers.

Note: For more information about ENC properties, see the encUtilCmd Command Reference. Also, see the ENC Gateway Policy Group topic in the Configuration Policy section of the DSM Explorer Help.