Typically, when you install Data Transport Service on an existing computer running CA ITCM, the installation process automatically executes the dtsbpv program. The dtsbpv program automatically decides whether the DTS Business Process Views need to be installed, upgraded, or both installed and upgraded. The program then automatically performs the required installation, upgrade, or both of the Business Process Views on that computer.
In other words, the dtsbpv program adds to or upgrades the Data Transport Service classes and objects stored in the MDB. Normally, the installation or upgrade of these Business Process Views occurs automatically, without user input, during the Data Transport Service installation process.
On rare occasions, however, the dtsbpv program does not run successfully during the Data Transport Service installation.
If you are not certain whether the dtsbpv program completed successfully or if you know that program failed, you should run it manually. Also, even if the initial installation of the Business Process Views was successful, you can reinstall them again later, if necessary. For example, you might reinstall the Business Process Views to re-initialize the Data Transport Service NOS classes.
Note: Running the dtsbpv program item clears any previously established Data Transport Service classes and objects and replaces them with an empty Data Transport Service framework.
Note: Run the dtsbpv program only on the computer on which CA ITCM and the Data Transport Service Network Object Server (NOS) component have been installed.
To run the dtsbpv program from the command line, enter the following command:
dtsbpv
If you want to uninstall (dtsbpv -u) and reinstall your Data Transport Service Business Process Views on a computer, enter the following commands from the command line:
dtsbpv -u dtsbpv
|
Copyright © 2013 CA.
All rights reserved.
|
|