Initial Installation
When installing CA IDMS VSAM Transparency in the CICS environment, CICSOPTS will be assembled and IDMSINTC at CICS startup and shutdown. Additionally, be sure that PPT link edited to create IDMSINTC. This is done automatically if CA IDMS VSAM Transparency is installed as part of an integrated installation. All parameters for CICSOPTS that are required for the VSAM Transparency will be automatically generated by the CAISAG installation utility when you indicate the product is to be installed, either as part of an integrated install or as a single product during ADDON processing.
Modifying CICSOPTS
If you need to reassemble CICSOPTS to change any installation options, edit the CICSOPTS member, re-assemble your CICSOPTS module and linkedit IDMSINTC. Take the job control to do this from the job control that was generated by CAIIJMP for your initial base tape installation.
Note: For more information on the CICSOPT macro and its parameters, refer to the CA IDMS System Operations Guide.
Important
Be sure the PLT entries are created to execute entries for CA IDMS modules have been added to you CICS system. These are used by IDMSINTC in setting up the CA IDMS environment.
Files to be accessed through the VSAM/T must be defined through the FCT assemblies to be initially closed, enabled so that CICS does not attempt to open them until IDMSINTC has been started.
In order for VSAM/T to work when IDMSINTC is defined in the PLT to be executed at startup, CA IDMS CV must be brought up. If CICS is brought up before CA IDMS CV is brought up, IDMSINTC must be started through a transaction code. Before starting IDMSINTC, take measures to prevent applications from attempting to access the VSAM/T files so that you can avoid OPEN errors.
Note: For more information on adding PPT entries, see the CA IDMS Installation Guide for your operating environment. For information on the IDMSINTC macro and its parameters, refer to CA IDMS System Operations Guide.
|
Copyright © 2014 CA.
All rights reserved.
|
|