Using Lock Monitor › Supported Attributes

Supported Attributes

The Lock Monitor supports a profile attribute for a user-specific default REFRESH interval. The Lock Monitor's default REFRESH interval is five seconds. The profile can override the default REFRESH interval by specifying the LMONRFSH attribute with an attribute value identifying the number of seconds in the interval.

If an attribute value is specified for LMONRFSH in the profile, it becomes the default value in the Lock Monitor session unless one of the following is true:

• The attribute value is nonnumeric; the Lock Monitor default is used.
• The value is greater than any timing interval in the DC system definition; the largest system defined value, minus 1, is used.

Note: For more information about defining a profile, see Chapter 3:

Automatic screen update

Automatic update of the screen requires unsolicited reads, which are not supported by all TP monitors, most notably UCF. When using LOCKMON under such a TP monitor, you must press Enter to update the display.