DCMT Task Commands › DCMT ABORT Command › DCMT ABORT Command Usage

DCMT ABORT Command Usage

Using the DCMT ABORT command

In response to DCMT ABORT, DC/UCF displays the following message (unless the command was entered from the operator's console or by an unauthorized user):

ABOUT TO SHUT DOWN SYSTEM system-number, TYPE 'Y' TO CONTINUE

Enter one of the following user responses:

• Enter the letter Y to abort the system. In this case, or if the command was issued from the operator's console, DC/UCF displays the following message and then aborts the system:

  DC260002  USER:user-id    IDMS-DC IS BEING ABORTED
  

  If you issued DCMT ABORT from a non console terminal, your terminal is logged off at this point. In this case, you do not receive additional abort messages at your terminal.

• Enter anything other than Y to instruct DC/UCF to ignore the abort request. In this case, DC/UCF resumes normal operation after displaying the following informational message:

  DC260905  USER:user-id  INVALID RESPONSE, SHUTDOWN ABORTED