Standard Dictionary Reports—DREPORTS › Producing Dictionary Reports › Parameters

Parameters

General syntax rules for the CA IDMS reports are presented in Chapter 1:. Syntax rules specific to the DREPORTs are described below:

dREPORT dreport-number

Identifies the report to be run. DREPORT identifies the report as a dictionary report; the D of DREPORT is optional. If D is specified, DREPORT must begin in column 1; if D is not specified, REPORT must begin in column 2.

Dreport-number is the 3-digit report number. Leading zeros can be omitted. Dictionary report numbers are shown in DREPORT Listing table and in Tables 2-2 through 2-6 in this section.

Multiple reports can be requested in the same job run with the following exceptions:

• KEY reports cannot be requested in the same run with detail, summary, cross-reference, or special-purpose reports.
• DREPORTs 009 and 010 cannot be run together.

KEY

Identifies the key report being requested. KEY must be entered in columns 2-4.

key-field-name

Identifies the key field name of the entity type being reported on. Valid key field names for each entity type are listed in DREPORT Key fields table.

'key-value'

Identifies the entity occurrence of the type specified in key-field-name; key-value must be enclosed in single quotation marks. If the quoted value is smaller than the field length shown in Key Field Names for Key Reports table, CA Culprit for CA IDMS pads the value with spaces on the right; if the value is shorter, CA Culprit for CA IDMS truncates the value to the specified length.