This section lists the error codes that can be issued by the DC batch simulator or from SYSIN/SYSOUT and sequential log files. These codes are issued as part of messages that indicate problems in accessing files. When a file I/O error occurs at open time, the code and associated message(s) are displayed on the operator's console. When the error occurs at run time, the code and associated message(s) are written to the system log.
The following file error codes are listed in numerical order, accompanied by reasons for the codes.
Reason:
The I/O operation has been completed successfully.
Reason:
The file could not be found in RHDCFTAB.
Reason:
The file is at EOF.
Reason:
The file is already open.
Reason:
The file is not open.
Reason:
A system internal error has occurred.
Reason:
An I/O error has occurred.
Reason:
A request has been made that is not compatible with the file.
Reason:
An attempt has been made to access a file; however, the file has been assigned the IGN attribute.
Reason:
An attempt to access a source system library has failed; the library could not be opened.
Reason:
An attempt to access a source system library has failed; an error has occurred during an attempt to open a private library.
Reason:
An attempt to access a source system library has failed; a usable library could not be found.
Reason:
An attempt to access a source system library has failed; a member could not be found.
Reason:
An attempt to access a source system library has failed; an I/O error has occurred during a read operation.
Reason:
An attempt to access a source system library has failed; an invalid calling code has been encountered. This is a system internal error.
|
Copyright © 2014 CA.
All rights reserved.
|
|