Reason:
This message appears only under z/VSE and always appears on SYSLST. If OPERATOR CORRECTION or ACCEPT FROM CONSOLE is in effect, it also appears on SYSLOG. The starting and ending columns provided in the SET statement are in error either because the ending column is greater than 80 or the starting column is less than the ending column. The starting and ending columns have been automatically reset to what they were before the SET statement. If this is not acceptable, correct the SET statement and rerun the job.
Module:
RHDCDFRC
Severity:
0
|
Copyright © 2014 CA.
All rights reserved.
|
|