Reason:
A DCMT VARY LU command that requested a change in the number of sessions has failed because the maximum number of sessions requested exceeds the number of physical terminals defined at system generation time with the indicated VTAM node name and modeent name. Retry the command, specifying a smaller MAXSES value. Use the DISPLAY LU MODEENT command to display the maximum number of physical terminals allowed. If more sessions are required, define additional physical terminals at DC/UCF system generation time.
If the MODEENT parameter was not used or if ALL was specified, each modeent for the indicated logical unit was varied individually. In this case, the message indicates that at least one modeent was not varied, but that others may have been varied successfully. An indication of the modeents that were varied and of those that were not varied is displayed at the operator's console and in the system log. The final session values can also be examined by using a DCMT DISPLAY LU command.
Module:
RHDCMTLU
Severity:
0
|
Copyright © 2014 CA.
All rights reserved.
|
|