Reason:
A DCMT VARY LU command has failed for the indicated logical unit 6.2 device because the entire modeent has been put out of service on the remote logical unit.
If the MODEENT parameter was not used or if ALL was specified, each modeent for the indicated logical unit was varied individually. In this case, the message indicates that at least one modeent was not varied, but that others may have been varied successfully. An indication of the modeents that were varied and of those that were not varied is displayed at the operator's console and in the system log. The final session values can also be examined by using a DCMT DISPLAY LU command.
Module:
RHDCMTLU
Severity:
0
|
Copyright © 2014 CA.
All rights reserved.
|
|