Reason:
During a DC debugger session, the current CME in the CA ADS dialog was flagged to be a breakpoint, but no breakpoint was ever established for that CME with the debugger AT command. The probable cause is that the CME was modified either by a DCMT VARY MEMORY command or by the debugger SET command. Breakpoints can be set only with the AT command. To correct the problem, QUIT the debugging session and begin again with the debugger setup phase for the current dialog.
Module:
ADSOCDRV
Severity:
0
|
Copyright © 2014 CA.
All rights reserved.
|
|