JCL Editing Commands › Entering Commands › Scroll Options

Scroll Options

 ┌ Page            ┐
 │ Half            │
 │ Csr             │
 └ number-of-lines ┘

Page

Specifies that a whole screen is to be scrolled whenever an UP, DOWN, RIGHT, or LEFT command is used.

Half

Specifies that a half screen is to be scrolled whenever an UP, DOWN, RIGHT, or LEFT command is used.

Csr

Specifies that the line with the cursor on it is to become: the bottom line displayed whenever the UP command is used, the top line whenever the DOWN command is used, the left-most column whenever the RIGHT command is used, or the right-most column whenever the LEFT command is used.

number-of-lines

Specifies that this number of lines are to be scrolled whenever an UP, DOWN, RIGHT, or LEFT command is used.

Use scroll options to specify how much of the screen is scrolled when you use an UP, DOWN, RIGHT, or LEFT primary command (or corresponding PF key) by itself.

At the far-right side of the second line on the Edit screen, the word SCROLL appears followed by one of the scroll options. To change the current setting, enter one of the other options over the current setting. The scroll option you set remains in effect until you enter a different setting.