Use the O (overlay) Command in conjunction with the C (copy) and M (move) line commands to copy or move source lines over the line containing the O or block of lines containing the OO command. The syntax for the O (overlay) Command is:
O = number-of-lines
where:
number-of-lines—specifies the number of lines to be overlaid.
O—specifies a single line to be overlaid.
On—specifies the first of n lines to be overlaid.
OO … OO—specifies the first and last lines of a block to be overlaid.
Default: 1
The following are the rules that you can follow while using O (overlay) command:
|
Copyright © 2013 CA.
All rights reserved.
|
|