The D (delete) Command is used to delete a line or block of lines. No other Line Commands can be entered on the lines to be deleted. The syntax for the D (delete) Command is:
D = number-of-lines
where:
number-of-lines—specifies the number of lines to be deleted.
D—specifies a single line to be deleted.
Dn—specifies the first of n lines to be deleted.
DD … DD—specifies the first and last lines of a block of lines to be deleted.
The following are the rules that you can follow while using D (delete) command:
|
Copyright © 2013 CA.
All rights reserved.
|
|