CA IDMS DMLO provides the following CLIST execution modes:
Selection of execution mode is done with the SET CLIST FAST/STEP command or with the Options screen.
Specification of LEARN Mode is done with the LEARN ON/OFF command or with the Options screen.
FAST Mode execution executes series of commands without interruption until a stopping point is reached. A stopping point is any error condition, a PAUSE or PROMPT command, or end of the CLIST. If an error condition occurs, execution will revert to STEP Mode. FAST Mode does not provide any screen displays until a stopping point occurs.
STEP Mode execution executes one command at a time and displays the results of that command. You must press the ENTER key to cause the next command to be executed. In between CLIST commands you may enter additional commands to be executed. When you press the ENTER key without a command line entry, the CLIST will execute its next command.
During STEP Mode, CA IDMS DMLO displays the next command to be executed in the message area of the display.
The LEARN Mode for command input during STEP Mode CLIST execution will execute and permanently insert into the CLIST source any commands which you enter when the CLIST is paused.
IFC and REPEAT commands may not be entered during LEARN Mode execution.
Use the LEARN ON/OFF command to initiate/terminate LEARN Mode. You may enter the command before starting CLIST execution, or at any time during execution. It may also appear as a command within the CLIST itself.
The CA IDMS DMLO display indicates that you are in LEARN/STEP Mode.
|
Copyright © 2014 CA.
All rights reserved.
|
|