With this command, you can establish, reset, or turn off the periodic display. SET INTERVAL can also be issued to change the option you selected for the DSPLYINT parameter.
Requests an interval in minutes, where the interval is an integer between 1 and 120, inclusive. The timing of a display interval begins each time a step begins. If a periodic display interval was already active (selected by using the DSPLYINT parameter), it is canceled and reset to the new interval value. SET INTERVAL 0=SET INTERVAL OFF.
Cancels the current periodic display interval (if active) or the display at the completion of each step (if active). You can then request status or set a new interval.
Specifies that instead of a periodic display, you want status information to be displayed on demand. When REQUEST is used, a status display is produced only in response to the DISPLAY STATUS operator command. REQUEST cancels the current periodic display interval, if one was active. REQUEST also cancels status displays at step initiation and termination.
Cancels the current periodic display (if active) and tells CA IDMS/DB Reorg to automatically display step initiation and termination statistics. If a SET INTERVAL interval command is issued after a SET INTERVAL STEP command, status information is displayed when each step starts and ends.
|
Copyright © 2014 CA.
All rights reserved.
|
|