Overview

A restart capability is built into the CA Culprit output phase to permit independent execution of the output phase for any or all of the reports produced by the run. This capability allows the following changes from the typical run procedures:

One run can produce reports on different types of output paper, such as special forms. To print reports on different types of paper, the output phase is run separately for each report or group of reports that uses the same type of output medium.
More than one copy of a report can be printed by running the output phase two or more times.
Execution of the output phase can be resumed after an interruption occurs during a print operation.

Using Restart

To use the restart capability, a RESTART parameter must be defined in the CA Culprit execution JCL.

More information:

Execution JCL