Install Connector Xpress Silently

Connector Xpress supports a silent mode of installation. To run a silent install, it is necessary to create a response file.

Follow these steps:

In a command window, navigate to where you extracted the Connector Xpress files, then to the following subfolder:
```
Provisioning/ConnectorXpress
```
Do either of the following depending on whether you want to install the component as you create the response file, or whether you want to create a response file template to use with a silent install at a later time:
- To create a response file and install the component at the same time, enter the following command and then run through the installation:
```
setup -options-record install_response_file
```
- To create a response file, but not install the component, enter the following command and then enter the required values in the template:
```
setup -options-template install_response_file 
```
Note: Use fully qualified path names when generating and running response files. For example, responsefile.txt is not valid but C:\responsefile.txt is valid.
Start the silent installation using the following command:
```
setup -options install_response_file -silent
```