Previous Topic: TILPARMSNext Topic: TILTAB50

Starting Your Product › How to Configure Without CA CSM › Configuring Host Encyclopedia and Host Construction › Establish the Environment › Use Saved Parameters to Configure the Environment › Modify TILPARMS

Modify TILPARMS

Follow these steps:

  1. Copy the TILPARMS member into the JCL data set for the new installation.
  2. To edit TILPARMS, use the following steps:
    1. Locate the line that contains @TILCSCHM.
    2. Change and verify the value to the right of @TILCSCHM to the Current Schema to update the schema to CA Gen 8.5.

      Note: For information about the schema designation for Current Schema, see the Release Notes

    3. Locate the line that contains @TILAPREF<data set prefix> and change the value of <data set prefix> to the new prefix used for CA Gen 8.5.

      Note: If the CLIST suffix is different, change it now.

      The SASCI3 index was new in AllFusion Gen 7 and should exist in a TILPARMS copied from an AllFusion Gen 7.x release.

    4. The CICS Sockets Load library is not required to build generated applications and has been removed. When a TILPARMS copied from an earlier CA Gen release contains an entry for the CICS Sockets Load library TCPIP.SEZATCP, remove it.
  3. On the CA Gen Main Menu command line, type the following and press Enter: 
    TSO %CEINSTAL

    The Encyclopedia Maintenance Menu displays.

  4. Select option 1 and press Enter.

    The Installation Variables Management Menu displays.

  5. Select option 1 and press Enter.

    The Set Library Names screen displays.

  6. Set the Data set Prefix to point to your new data sets on the Set Library Names screen.
  7. Verify the JCL library suffix is correct and press F3.

    The Installation Variables Management Menu displays.

  8. To read in the TILPARMS member you edited, select option 12. Retrieve variables from external data set.
  9. Step through options 2 through 9 to accept (F2) and save (F6) the edits to TILPARMS. When you select option 7 or 8, depending on the type of storage you are using, it builds the TILTAB50 table explained in the section TILTAB50 in this guide.
  10. After all settings are correct, use option 10, Check variables to verify the validity of the settings.
  11. To save the new settings to TILPARMS, choose option 11. Save variables to external data set.