Defining the Target Configuration › Model Definition › Add a Model

Add a Model

Follow these steps:

With the IT window displayed, select Option 1. The Installation Tool window is displayed.

1. Select Option 3, Maintain Configuration Information.

   The Selection List screen is displayed.

2. Select the target configuration you want to define models for and press Enter.

   The Target Definition screen is displayed.

3. Press F2 to add a model.

   The Model Definition screen is displayed.

4. Tab to the Model field. Type a valid model name. This is the name of the model on the code generation platform. It appears in the ICM.
5. For DB2 scripts, tab to the DB2Sys field and type the DB2 subsystem ID. This is used during DDL installation, and DB2 bind steps.
6. Press Enter to add the Model.

   The system responds with the message:

   Processing has completed normally
   

7. Press F5 to display the Specify Locations screen. This screen is used to specify model level data sets for the different components of the model in the target environment. For a description of locations, usage, and data set attributes, see the locations table in the To Add a Target section in this chapter.

   Note: A data set name can be up to 44 characters long. Quotes are required. Data set name validation is not performed. All data sets must be created outside the Installation Tool. Data set names can be deleted or changed by overwriting the existing values. Ensure that all Load libs and Ext Ab libs are created as a PDSE (DSNtype=library) data set.

8. Press Enter to process the changes.

   The system responds with the following message:

   Location updates were successful.
   

9. Press F3 to display the Installation Tool window.