Customizing Scripts and User Exits › Tokens › Modifying Tokens

Modifying Tokens

The decomposition report is viewed using the Installation Tool. Use this report to view the values associated with certain tokens for a specific target configuration, Model, BusSys, load module, or load module member.

Token values can be viewed to verify the components each remote file has been split into and the locations in which they have been stored. Only token values can be viewed using the decomposition report. To add, change, or delete location (LOC) tokens, Target Configuration (TAR) tokens, Model (MOD) tokens, BusSys (BUS) tokens, or option (OPT) tokens, use the Installation Tool's Maintain Configuration Information selection.

Load module definition (LMD) and load module member (LMM) token values are set when a remote file is registered. These values are taken from the information stored in the ICM of the remote file being registered. There are three ways to change the values for these tokens:

• Delete the load module definition using the Install Load Module option (selection 2 from the Installation Tool window) and register the remote file again.
• Delete the entire BusSys where the load module belongs and then redefine the BusSys and reregister the remote file.

  Make the appropriate selection changes on the code generation platform, regenerate the remote file, move it to the target system, and register it again.